8
-VERTIGO COMBAT-V07-ENG.DOCX - GENERAL INFORMATION
Carrer Argenteria 8-10, Pol. Ind. Riera de Caldes. 08184 Palau-Solità i Plegamans (Barcelona - Spain) T + 34 931 70 16 55.
1.1.3 General recommendations
In addition to the specific recommendations of each procedure, these general recommendations must be taken into account.
• If parts replacement is necessary, replace the parts with Genuine Parts or their proven equivalence.
• When removing parts that are to be reused, keep them arranged in an orderly manner so that they may be reinstalled in the proper order and
orientation.
• Be sure to use special tools when instructed.
• Make sure that all parts used in reassembly are clean. Lubricate them when specified.
• Use the specified lubricant, bond, or sealant.
• Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, self-locking nuts, cotter pins, circlips and certain other parts as
specified, be sure to replace them with new ones. Also, before installing these new parts, be sure to remove any leftover material from
the mating surfaces.
• Never reuse a circlip. When installing a new circlip, take care not to expand the end gap larger than required to slip the circlip over the shaft. After
installing a circlip, always ensure that it is completely seated in its groove and securely fitted.
• Use a torque wrench to tighten fasteners to the specified torque. Wipe off grease and oil if a thread is smeared with them.
• After reassembling, check parts for tightness and proper operation.
• To protect the environment, do not unlawfully dispose of used motor oil, engine coolant and other fluids: batteries, and tires.
• To protect Earth's natural resources, properly dispose of used motorcycle and parts.
To Next Page
Loading...