Need help?Do you have a question about the VESDA LaserPLUS VLP-000 and is the answer not in the manual?
Details on selecting appropriate wire sizes based on power ratings.
Power requirements for the detector and modules at 24VDC.
Recommended RS485 cable type and characteristics for VESDAnet.
Steps to verify the detector and mounting location before installation.
Procedure for safely removing the front cover and accessing internal components.
Identification of key components within the detector housing.
Instructions for rotating display/programmer modules for inverted mounting.
Method for creating entry points for cables using knockout holes.
Description of available exhaust air outlet positions and selection.
Instructions for securely attaching the mounting bracket to the surface.
Steps for mounting the detector onto the prepared bracket.
Guide for connecting sampling air pipes to the detector's inlet ports.
Methods for routing wires into the enclosure using glands or conduits.
Specific instructions for using cable glands with entry ports.
Specific instructions for connecting conduits to the enclosure.
Overview of the terminal layout and pin assignments on the termination card.
Step-by-step guide for connecting wires to the termination card.
Specific instructions for wiring power supply to the termination card.
Guidance for connecting VESDAnet communication wiring.
Instructions for wiring relay outputs to the termination card.
Steps for reassembling the detector after wiring.
Checks for correct pipe joint sealing and bonding at air inlet ports.
Procedure for safely powering on the detector and system.
Instructions for logging into the system using programmer or PC.
How to verify communication between devices on the VESDAnet loop.
Procedure for normalizing air flow and clearing associated faults.
Test to verify the detector's ability to sense smoke.
General| Brand | VESDA |
|---|---|
| Model | LaserPLUS VLP-000 |
| Category | Smoke Alarm |
| Language | English |
To Next Page