Need help?Do you have a question about the VESDA LaserPLUS VLP-002 and is the answer not in the manual?
Guidance on inspecting the detector for damage, verifying the model, and checking the mounting location.
Steps for securing the mounting bracket to the installation surface using a drilling template.
Procedure for physically mounting the LaserPLUS detector onto the secured mounting bracket.
Instructions for connecting sampling air pipes to the inlet ports, including notes on pipe fit and gluing.
Step-by-step guide for stripping wires and connecting them to the termination card sockets.
Specific instructions and diagram for connecting power supply wires to the termination card.
Details on connecting VESDAnet wires, including closed and stand-alone loop configurations.
Instructions for connecting relay wires to the termination card based on site requirements and Figure 13.
Detailed steps for safely powering up the LaserPLUS detector and checking voltage.
Procedure for normalizing airflow and clearing associated faults using LCD or PC programmer.
Procedure to test the detector's ability to sense smoke using Display, LCD, or PC programmer.
General| Model | VLP-002 |
|---|---|
| Detection Technology | Laser-based |
| Detection Principle | Light scattering |
| Power Supply | 24V DC |
| Operating Voltage | 18 - 30 VDC |
| Weight | 3.5 kg |
| Type | Aspirating Smoke Detector |
| Sensitivity Range | 0.005 to 20% obscuration/m |
| Air Sampling Method | Aspiration |
| Sampling Method | Active |
| Max Coverage Area | 2000 m² |
| Coverage Area | Up to 2000 sq. meters |
| Alarm Levels | Alert, Action, Fire 1, Fire 2 |
| Operating Temperature | 0°C to 39°C |
| Humidity Range | 0 to 95% non-condensing |
| Communication Interface | RS-485 |
| Aspiration | Yes |
To Next Page