VESDA LaserPLUS VLP-002 - Installation Checklist; Pre-Handover Installation Checks

LaserPLUS Installation Manual VESDA
®
22 Version 1.5
9. Installation Checklist
Site Name: ………………………………………………………………………
Zone: ……………………………………………………………………………..
Detector Serial Number/s: ……………………………………………………
Perform the following checks listed below to ensure that all the necessary items are
completed before handing over to a commissioning engineer.
INSTALLATION CHECKS
Yes No
1. Was the LaserPLUS detector intact in the box?
 
2. Is the LaserPLUS securely locked onto its mounting bracket?
 
3. Are the sampling air pipes firmly connected to the air inlet ports?
Note-The pipes must not be glued.
 
4. Have the power wires been connected to the correct terminals
on the termination card?
 
5. Have the alarm signalling wires been terminated to the correct
terminals on the termination card?
 
6. Have the VESDAnet wires been connected to the correct
terminals on the termination card?
 
7. Has the plug at the exhaust port been removed and the exhaust
pipe (if fitted) not glued?
 
8. Has the front cover been replaced correctly?
 
9. Have the Preliminary System Checks been performed?
 
10. Is the air sampling pipework installed and checked as per the
site plans?
 
Installation of your LaserPLUS is now complete.
Name of Installer: ……………………………………………………………….
Signature: .................................................................................……………
Date: ………………………………………………………………………………