Need help?Do you have a question about the VESDA VESDA-E VEP-A00-P and is the answer not in the manual?
Covers general mounting requirements and specific methods for installation.
Details electrical connections, socket locations, power, communication, relays, and GPIs.
Steps required to establish communication between Xtralis VSC software and the detector.
Details various methods for connecting to the detector for configuration and monitoring.
Explains access control, authentication, and security advice for the detector.
Details various settings available for customizing detector behavior via Xtralis VSC.
Process for the detector to learn optimal smoke alarm thresholds based on environment.
Process for the detector to learn optimal airflow thresholds for the installed environment.
Steps for replacing the detector's air sampling filter to maintain performance.
Steps for replacing the detector's aspirator unit.
Steps for replacing the smoke sensing component of the detector.
General| Model | VESDA-E VEP-A00-P |
|---|---|
| Type | Aspirating Smoke Detector |
| Laser Class | Class 1 |
| Number of Sampling Pipes | Up to 4 |
| Pipe Length | Up to 100m per pipe |
| Current Consumption (Alarm) | 600mA |
| IP Rating | IP30 |
| Event Log | 1000 events |
| Sensitivity Range | 0.005% to 20% obs/m |
| Coverage Area | Up to 2000 m² |
| Power Supply | External Power Supply |
| Operating Voltage | 18V to 30V DC |
| Operating Temperature | 0°C to 39°C |
| Storage Temperature | -20 to 60°C |
| Operating Humidity | 10% to 95% RH, non-condensing |
| Relay Outputs | 3 relay outputs |
| Relay Contact Rating | 2A @ 30V DC |
| Communication Protocol | VESDAnet |
| Approvals | EN 54-20, UL, FM, LPCB |
To Next Page