Vespa 90 - Fuel Supply; Starting; Setting the Scooter in Motion; Gear Change

OPERATION
FUEL SUPPLY
STARTING
SETTING THE
SCOOTER IN
MOTION
GEAR CHANGE
OPERATING INSTRUCTIONS
INSTRUCTIONS
Ensure that the fuel tank breather is always
clean. Use a mixture 2 % by volume
during and after running-in.
- Carry out the instructions indicated on
fig. 6. Do not use the choke when the
engine is warm; as soon as the engine
is running smoothly bring the choke
control back to its normal position.
- With the engine running at idling speed
declutch and rotate the gear change
twist grip to the position of first gear
(fig. 6). For setting the vehicle in motion
slowly let in the clutch and gradually open
the throttle.
- Close the throttle, declutch and rotate
the gear change grip to a higher or lower
gear, as the case may be (fig.7).
NOTES
In case of hard
starti ng see page
32.
Do not attempt to
ride the vehicle un-
less the handlebars
rotate freely.
When It is neces-
sary to slow down
do not hesitate in
changing to a lower
gear.
12-