ALTIMETER
To enter ALTIMETER mode (height measurement) press the
Altimeter button when in TIME mode. Once in ALTIMETER
mode, you will see the Altitude and the Temperature.
*NOTE: the Watch is shipped set with a Factory default mode
and needs to be adjusted in order to display your Altitude ac-
curately. For an accurate Altitude reading the Air pressure must
be accurate as well.
To adjust the display of the ALTIMETER units:
- To alternate between °C - Meters > °C – Feet > °F – Meters
> °F – Feet, press and hold the Altimeter button until you reach
your preferred combination of Temperature and Altitude units.
To calibrate the ALTIMETER:
There are 5 different modes to calibrate the ALTIMETER:
TEMP (Temperature Adjust), ZERO (Relative Height), ALTI
(Location Height), SEAP (Sea Level Air Pressure), and FDEF
(Factory Default Height). You may have to use the ALTI and
SEAP together to obtain the correct measurement.
*Note: set the FDEF mode to NO (off) before you proceed
with other adjustments.
TEMPERATURE ADJUST:
- Press and hold the Light button.
- TEMP: This mode will allow you to adjust the temperature.
- Press the Barometer or Altimeter buttons to begin adjusting
the temperature.
- Press the Light button to exit.
To Next Page
Loading...
