19
ALTIMETER continued
- Use the Barometer and Altimeter buttons to increase and
decrease the selected number.
- Press Mode to advance.
- Repeat until the correct Altitude is displayed.
- Press the Light button to exit.
AIR PRESSURE INPUT:
- Look up your local weather to nd out the current Air Pres-
sure in your location.
- Press and hold the Light button.
- Press Mode button 3 times.
- AIRP: This is the Air pressure Input Mode.
- Press Barometer or Altimeter button to start inputting your
location’s air pressure.
- Use the Barometer or Altimeter buttons to increase or
decrease the selected number.
- Press Mode to advance.
- Repeat until you have your Air Pressure Inputted.
- Press the Light button to exit.
FACTORY DEFAULT ADJUST:
- Press and hold the Light button.
- Press mode button 4 times.
- FDEF: This is the factory default setting.
- Press Barometer or Altimeter buttons to adjust.
- Select either YES or NO.
- Press the Light button to exit.
- NOTE: Vestal suggests selecting NO to turn this setting off.
ALTIMETER continued
- Press Mode button to jump to the degrees display.
- Use the Barometer and Altimeter buttons to increase and
decrease the selected number.
- Press Mode to advance.
- Repeat until the correct temperature is displayed.
- Press the Light button to exit.
- NOTE: Vestal suggests not adjusting this at rst.
RELATIVE HEIGHT:
- Press and hold the Light button.
- Press Mode button 1 time.
- ZERO: Relative height (sets your Altitude to zero. Allows
you to see the height you have gained or loss from a certain
location).
- Press Barometer or Altimeter buttons to adjust.
- Select either YES or NO.
- Press the Light button to exit.
ALTITUDE INPUT:
- Press and hold the Light button.
- Press Mode button 2 times.
- ALTI: This mode will allow you to adjust your current
Altitude.
- Press the Barometer or Altimeter buttons to begin adjusting
the temperature.
- Press Mode to jump to the Altitude input.
To Next Page
Loading...
