VESTEL 49FA5000 - Input Sources - Can Not be Selected; No Picture; No Sound; Poor Picture

English-56
Troubleshooting & Tips
Tv will not turn on
Make sure the power cord is plugged in
securely to wall outlet. The batteries in the
remote control may be exhausted. Press the
Power button on the TV.
Poor picture
• HaveyouselectedthecorrectTV
system?
• Lowsignallevelcancausepicturedis-
tortion.Please check antenna access.
• Check if you have entered the correct
channel frequency if you have done
manual tuning.
• The picture quality may degrade when
two devices are connected to the TV at
the same time. In such a case, disconnect
one of the devices.
No picture
• NoPicturemeansthatyourTVisnot
receiving a transmission. Have you se-
lected the correct button on the remote
control? Try once more. Also make sure
the correct input source has been selec-
ted.
• Istheantennaconnectedproperly?
• Istheantennacabledamaged?
• Aresuitableplugsusedtoconnectthe
antenna?
• Ifyouareindoubt,consultyourdealer.
No sound
• Hasthe TVbeensettomute?Tocancel
mute, press the “
” button, or increase the
volume level.
• Soundiscomingfromonlyonespeaker.Is
the balance set to one extreme? See Sound
Menu section.
Remote control -
does not operate
• Thebatteriesmay beexhausted.
Replace the bateries.
Input sources - can
not be selected
• Ifyoucannotselectaninputsource,itis
possible that no device is connected. if not
• ChecktheAVcablesandconnectionsif
you have tried to connect a device.