EasyManua.ls Logo

Vetek WLC 1/A2 - Precautions; Maintenance; Power Supply; Warranty Conditions

Vetek WLC 1/A2
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. PRECAUTIONS
2.1. Maintenance
A. Please, read carefully this user manual before and use the device
according to its intended use.
B. Dead batteries (accumulators) should be utilized according to the law;
C. Devices that are to be withdrawn from use age should be sent back to
the producer or in case of own utilization do it according to the law.
In case of an elongated storage period in low
temperatures, it is not allowed the full discharge
of the accompanied batteries.
2.2. Power supply
Weighing indicators in plastic casing and WLC/B1 series can be supplied
from power adapters and NiMH rechargeable batteries (standard
equipment). New rechargeable batteries should be formatted according
to the description in the chapter 15.4.4. of this manual.
If you want to use normal batteries instead of rechargeable ones,
proceed as follows:
x Before installing non-rechargeable batteries turn on the device
and set <5.5.CHr6> to <no>, to switch off charging.
x Then install the batteries.
Installing batteries without changing <5.5.CHr6> to <no>
may cause damage of batteries and the indicator.
3. WARRANTY CONDITIONS
A. RADWAG is obliged to repair or change those elements that
appears to be faulty because of production and construction reason,
B. Defining defects of unclear origin and outlining methods of
elimination can be settled only in participation of a user and the
manufacturer representatives,
C. RADWAG does not take any responsibility connected with
destructions or losses derives from non-authorized or inappropriate
(not adequate to manuals) production or service procedures,
- 6 -

Table of Contents