INSTALLATION TESTS
Once installation is complete, the computer should be tested to
make sure it is working properly.
If there is no speed reading, make sure the timers (RT/TT) are
running, check the alignment and spacing between the
magnet and sensor or transmitter and make sure that the
head unit is completely snapped into position. If these checks do
not solve the problem, talk to an Authorized Vetta Retailer or
connect to www.vetta.com.
IMPORTANT: Following the installation tests above, make
sure that the spoke magnet locking screw and all zip ties are
properly tightened.
Tips: Rotating the angle of the transmitters or the handlebar
receiver (slightly), can sometimes improve the signals being sent
and received. Some bicycles have unusual frame tubes and angles,
so by adjusting the components, can aid in trouble shooting by
aligning the misdirected signals.
Step 1:
Step 2:
Advance the computer to the SPD/DST screen mode
using Button #2.
Pick up the front of the bicycle and spin the front wheel.
The computer should display a speed reading within 2-3
seconds.
To Next Page
Loading...
