Ⅴ. HOW TO USE
Before using the machine, please check:
(1)Power cord is securely plugged into a grounded, correctly rated outlet. Make sure the
power voltage and frequency are in accordance with the data specified on the nameplate
or in the instruction manual.
(2)The water inlet, outlet and hose are connected correctly and firmly, make sure there are
no leaks or clogs.
(3)Keep sufficient clearance between the chiller and its surrounding objects for heat
dissipation and convenient maintenance, with at least 30cm clearance around front (air
inlet) and sides and 60cm in back (air outlet). If the chiller is to be put in an aquarium
cabinet, the cabinet should have enough grilles for air circulation, or to be equipped with an
extra small exhaust fan.
If the 3 items above are OK, you may begin using your water chiller:
(1)Turn on water pump, making sure the Circulating Cooling Water System can run
normally without any blockage or leak.
(2)Turn on the chiller and use the Control Panel to set desired water temperature.
Adjust temperature
1.Plug the chiller into a socket of rated voltage and frequency, turn it on. The power
indicator light is on and the LCD shows the current water temperature.
2.Press “SET” to enter the setting. Press ▲ to turn up pre-set temperature, and press ▼ to
turn down pre-set temperature. The starting temperature difference is 2℉，for example, the
chiller needs to be set at least 2℉ lower than the actual water temperature to get it started.
The chiller needs to set at least 2℉ lower
The chiller needs to set at least 2
℉
higher
than the actual water temperature to heat.
To Next Page
Loading...
