Do not regulate the relief valve.
Avoid using any extension lines, which may overheat.
If you must use it, ensure that the minimum value is 14 AWG.
The product is thoroughly inspected at least once a year.
Replace any damaged or severely worn cable, hydraulic hose, labeling, or
warning labels.
Do not use this product until damaged or worn items are replaced.
Do not place an unbalanced or off-center load on the jack.
Incorrect load can cause equipment failure and possible personal injury.
Do not work under an elevated vehicle without prior support with mechanical
support or other appropriate methods.
When lifting the load, all precautions shall be taken to avoid vehicle movement.
When using the product on the road, the traffic may cause the already-raised
car to shake.
Turn off the engine and pull the handbrake tightly. It is best to use the brake pad
to prevent sliding. Please ensure that there is no one in the vehicle before using
it.
Do not enter the car or start the engine during the lifting process.
Do not touch the hot part, which may cause burns.
Warning: It cannot be used with a 50Hz power supply as it will damage the
machine. It must be used with a 60Hz power supply.
When operating the hydraulic equipment, please wear safety glasses.
The floor surface must be dry and flat with a minimum compressive strength of
500 psi.
Be careful with the cables and hydraulic hoses, and avoid being run over or
pressed by the car.
Remove all the jewelry when using this product.
Suspended jewelry and metal jewelry may get stuck in moving parts.
To Next Page
Loading...
