If the vehicle has a risk of falling from the platform, please clear the area in
advance.
Before approaching an elevated vehicle, make sure all four lock rods are in a
natural falling state.
Do not turn on the refueling plug on the power supply device when the lifting
platform starts working.
Do not pull the remote control cord or power cord to move the AC power supply
device, which will damage the power cord.
Contact an authorized service center for hydraulic technical support or repair
services.
The manufacturer has no warranty obligation for products repaired, modified or
damaged by unauthorized personnel due to misuse, abuse, accident,
negligence or improper handling.
Tips:
Always care to keep the product clean.
When not using the product, please withdraw all the parts to the original state.
Please use hydraulic equipment at room temperature, do not use hydraulic
equipment above 65℃ (150 ℉).
Overheating will soften the seal and weaken the hose material, causing oil
leakage or other equipment failures.
Do not raise the lift platform frame to a full expansion height without increasing
the vehicle load!
If you are using our product for the first time, a simple way to be familiar with
the operation is to control the product repeatedly up and down the platform
several times without load.
But make sure you don't take your products to the top when empty, actually just
lift them to about 200-300mm above the ground.
If you completely raise the platform to its maximum height, your platform may
get stuck.
Do not remove the tires of the vehicle and lower the platform to the ground.
To Next Page
Loading...
