1. Put the net (No.20)into cabinet(No.14).
2. Put the gun assembly (No.24) into cabinet (No.14), then put the steel washer
(No.22),rubber washer(No.23) on the air connector(No.21) in turn. Wrap 5 circles
teflon tape clockwise rotation on the joint and connect with the inner thread
connector of the cabinet .
3. Assemble the gloves(No.19) ,please note the left and right direction difference
and clamp them.(No.18)
4. Assemble the door locker(No.15) with front plate by M4*10 screw(No.16) and
nut(No.17).
5. Put the filter(No.28) into filter plate(No.27) and fix with the inside of rear cabinet
plate by M5*20 screw(No.25) and nut(No.26).
To Next Page
Loading...
