VEVOR SBC150 - Troubleshooting

- 6 -
4. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
REMEDY
Excessive
dust in the
cabinet.
1 Exhaust vent or air flow
is blocked.
2 Abrasive is worn.
3 Too much abrasive in the
cabinet.
4 Loose air line or fittings.
1 Clean vent and keep vent away
from any wall.
Connect to a suitable dust
exaction system
2 Replace
3 Remove excess
4 Check and tighten all air fittings.
Uneven
blasting.
1 Too much abrasive in
cabinet.
2 Moisture inside cabinet.
1 Remove excess
2 Check air line for moisture
Inadequate
speed or
efficiency of
blast.
1 Abrasive is worn.
2 Pressure is too low
1 Replace
2 Check that there are no supply
blockages or leaks Increase
pressure. Max;90psi
Static
electricity.
1 Dry weather conditions
1 Leave the work piece to stand
for a while
Blast
pattern too
wide or
ineffective.
1 Nozzle blocked or be
worn
1 Unblock or replace nozzle