× DO NOT attempt to pull the transformer plug from the mains socket by the lead.
× DO NOT use any other type of transformer with the cabinet.
× DO NOT try to open or dis-assemble the transformer plug or charging base.
× DO NOT use the transformer plug to power any other electrical item.
× DO NOT get the transformer wet, or use in wet, damp conditions (for indoor use
only).
WARNING! NEVER substitute a standard 13 amp 3 pin plug, or any other type of
plug, for the transformer plug.
1.2 GENERAL SAFETY
WARNING! Ensure Health & Safety, government and local authority regulations
relating to the the use of shot blasting are adhered to when using this equipment.
Familiarize yourself with the applications. limitations and potential hazards peculiar
to the cabinet.
WARNING! Disconnect the cabinet from the mains power and the air supply
before attempting to change accessories or carry out any servicing or
maintenance.
√ Maintain the cabinet in good condition Replace or repair damaged parts.Use
genuine parts only. Unauthorized parts may be dangerous and will invalidate the
warranty.
√ Locate cabinet in a suitable work area and keep area clean.tidy and free from
unrelated materials. Ensure there is adequate lighting.
√ Use only dry abrasives such as proprietary brands of glass beads. silicon
carbide, aluminum oxide and silica sand. Never use fluids or mix fluids with
another media in the unit.
WARNING! Always wear approved eye or face and ear protection when operating
the cabinet.
√ Keep the unit lid closed and secured when in use.
WARNNING! Ensure correct air pressure is maintained and not exceeded.(Max
90psi).
√ Always keep the blast nozzle directed at the workpiece. Never use outside the
unit and always use with the lid closed.
To Next Page
Loading...
