√ Regularly check that the exhaust vent at the back of the cabinet is clear and not
blocked and that there is space between it and any wall.
√ Maintain correct balance and footing. Ensure the floor is clean and free from
blasting media spillage. Wear non-slip shoes.
√ Remove ill fitting clothing. Remove ties. watches,rings,and other loose jewellery
and contain and/or tie back long hair.
√ Keep children and non-essential persons away from the work area.
× DO NOT use the cabinet for a task it is not designed to perform.
× DO NOT operate the cabinet if any parts are damaged or missing as this may
cause failure and/or personal injury.
× DO NOT operate the cabinet with the lid open.
× DO NOT stand on the cabinet.
× DO NOT get the cabinet wet or use in damp or wet locations or areas where
there is condensation.
× DO NOT operate the cabinet when you are tired or under the influence of
alcohol, drugs or intoxicating medication.
× DO NOT leave the cabinet operating unattended.
√ When not in use disconnect from the electrical mains and the air supply.
NOTE! We strongly recommend that a suitable dust extraction system is used with
this unit if dust extraction is not used, media may be forced out of the joints as
pressure builds up. You can alleviate this to some extent by removing the white
blanking plug(Fig.1) situated on the upper left corner at the rear of the tank when
viewed from the front.This however will not substitute a suitable dust extraction
system.
2. DESCRIPTION＆SPECIFICATION
The SBC150 shot blasting cabinet is constructed of steel with double side
doors,replaceable viewing screen and internal illumination.
Supplied with a shot blasting gun the unit is suitable for glass beads,silicon carbide,
aluminum oxide and silica sand. Excellent for use in a wide variety of workshop
To Next Page
Loading...
