Important Note:
1. Due to logistics reasons, few metal sheets may become slightly
deformed, which could to be corrected by simple tools. Normally it is
easily done. But please consult customer service if the correction is
still not in place after you try. Customer service staff will provide
proper solutions in time.
2. The sealing foam can be punctured with a screwdriver before
assembly to facilitate the installation of screws (the holes would be
hidden by sealing foam).
7. FCC Information
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment!
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This product may cause harmful interference.
2)This product must accept any interference received, including interference that
may cause undesired operation.
WARNING: Changes or modifications to this product not expressly approved by
Cross pan head screw
M4*10
To Next Page
Loading...
