Install sandblasting gun, rubber and metal washer to the inner thread connector of
right cabinet plate.
Please note to wrap the Teflon tape for connector if necessary. To make sure no
air leakage.
Important Note:
1. Due to logistics reasons, few metal sheets may become slightly
deformed, which could to be corrected by simple tools. Normally it is
easily done. But please consult customer service if the correction is
still not in place after you try. Customer service staff will provide
proper solutions in time.
2. The sealing foam can be punctured with a screwdriver before
assembly to facilitate the installation of screws (the holes would be
hidden by sealing foam).
To Next Page
Loading...
