VEVOR SMART1 - Page 21

20
2.10 First, place the pad with the
adhered material on the edge of the
press wheel according to the
diagram below.
2.11 Press the LOAD
button when the
material is ready.
2.12 Prompt to
press the start
button.
2.16 Contour
cutting completed.
2.15 Press the
machine’s
LOAD/UNLOAD
button.
2.14 When
processing is
complete, the
software will prompt
you to press the
LOAD button.
2.13 Press the
start button on
the machine.