To Next PageTo Next Page
Need help?Do you have a question about the VEVOR 10190010215 and is the answer not in the manual?
Provides contact information for technical support and E-Warranty.
Read this material before using the product to prevent serious injury.
Wear protective gear, use hook for chips, check cutter integrity, turn off power.
Describes what annular cutters can cut, including various metals and non-metallic materials.
Details different shank types (Weldon, Universal, Fein) and their compatibility.
Describes installation steps for Weldon, Universal, and Fein shanks.
Provides a table of recommended cutting speeds for high speed steel annular cutters by diameter and material.
Specifies recommended feed speed ranges and their effect on chip formation.
Instructions on positioning the drill and starting the drilling process.
Tips to reduce wear and fracturing, including cooling, rigidity, and securing parts.
Advice on adjusting drilling feed at the start and end of the process.
Methods to resolve issues where the chip core gets stuck.
Guidance on identifying tool wear and when grinding is necessary.
Details for Annular Cutter Model 10190010215: Weldon shank, D.O.C. 2", various cutter diameters.
Details for Annular Cutter Model 10190010216: Universal shank, D.O.C. 2", various cutter diameters.
Details for Annular Cutter Model 10190010146: Weldon shank, D.O.C. 1", various cutter diameters.
Details for Annular Cutter Model 10190010213: Weldon shank, D.O.C. 1", various cutter diameters.
Details for Annular Cutter Model 10190010214: Weldon shank, D.O.C. 2", various cutter diameters.
Provides contact information for technical support and E-Warranty.
Read this material before using the product to prevent serious injury.
Wear protective gear, use hook for chips, check cutter integrity, turn off power.
Describes what annular cutters can cut, including various metals and non-metallic materials.
Details different shank types (Weldon, Universal, Fein) and their compatibility.
Describes installation steps for Weldon, Universal, and Fein shanks.
Provides a table of recommended cutting speeds for high speed steel annular cutters by diameter and material.
Specifies recommended feed speed ranges and their effect on chip formation.
Instructions on positioning the drill and starting the drilling process.
Tips to reduce wear and fracturing, including cooling, rigidity, and securing parts.
Advice on adjusting drilling feed at the start and end of the process.
Methods to resolve issues where the chip core gets stuck.
Guidance on identifying tool wear and when grinding is necessary.
Details for Annular Cutter Model 10190010215: Weldon shank, D.O.C. 2", various cutter diameters.
Details for Annular Cutter Model 10190010216: Universal shank, D.O.C. 2", various cutter diameters.
Details for Annular Cutter Model 10190010146: Weldon shank, D.O.C. 1", various cutter diameters.
Details for Annular Cutter Model 10190010213: Weldon shank, D.O.C. 1", various cutter diameters.
Details for Annular Cutter Model 10190010214: Weldon shank, D.O.C. 2", various cutter diameters.
General
