Ⅰ. Bacic Safety Rules
WARNING：Read all safety warnings, instructions, illustrations and
specifications provided with this appliance. Failure to follow all
instructions listed below may result in electric shock, fire and/or
serious injury.
1. Protective material must be removed before turning on the cutting plotter.
2. Check the label on the back side of the plotter to confirm that the rated voltage
required by the plotter matches the voltage of the power base.
3.Firstly make sure that the power switch is off, then plug the power supply into
grounded power outlet.
4.Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions, or has been damaged in any manner. Return appliance to the
nearest authorized service facility for examination, repair or adjustment.
5.Type X attachment: If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the manufacturer or its service agent.
6.Please do not touch the power cord with wet hands to avoid electric shock.
7.Please only use the power cord, data cable provided with this product, or
manufacturer-approved replacements.
8.Do not use outdoors. INDOOR USE ONLY
9.Please do not drop metal objects and liquids into the machine to avoid
malfunction.
10.After shutting down, you must wait another 5 seconds to turn on the cutting
plotter again, otherwise it will cause damage to the cutting plotter.
11.In thunderstorms, turn the power switch to OFF and unplug the power cord.
12.Please do not privately change the manufacturer's components.
13. Manufacturer reserves the right to change product specifications without prior
notice.
14.The manufacturer only bears the legal obligations of the product itself sold to
the users, and does not bear other losses caused by the malfunction of the
products.
15.Without our company’s permit, no part of this manual can be copied or
transmitted in any name.
16.Do NOT drag the carriage by hand.
To Next Page
Loading...
