Viatom Checkme - Unpacking and Initial Setup; Using the Checkme Monitor

8
IP22
Against ingress of solid foregin objects ≥12.5mm dimeter,
Against dripping(15° tilted)
Follow operating instructions
No alarm system.
3. Getting Started
3.1 Unpacking
Before unpacking, examine the packing case carefully for signs of damage.
If any damage is detected, contact the carrier or us. If the packing case is
intact, open the package and remove the equipment and accessories
carefully. Check all materials against the packing list and check for any
mechanical damage. Contact us in case of any problem.
Warnings and Cautionary Advices
 Save the packing case and packaging material as they can be used if
the device must be reshipped.
 Keep the warranty card, which is useful within the period of
warranty.
 When disposing of the packaging material, be sure to observe the
applicable waste control regulations and keep it out of children’s
reach.
 The equipment might be contaminated during storage and transport.
Before use, please verify whether the packages are intact, especially
the packages of single use accessories. In case of any damage, do
not apply it to patients.
3.2 Power On/Off
Press the Power On/Off button to power on the device. Press and hold
Power On/Off button for 2 seconds to power off the device.
3.3 Initial Settings
The first time when the Checkme is powered on, you can follow the steps
as below to set up your Checkme monitor.