Vibra SJ-E Series - Page 26

8.1 Limit Function Setup (cont.)
2 Selecting a function item
 
Press the Function key.
The display changes to the next item
[Limit Function].
3 Setting the limit function
 
リミット機能動作
Limit function
operations
Press the Zero/Tare key to set the
value on the rightmost side to [1].
4 Setting the judgement condition
 
常時判別
 
安定時判別
Judged at all times Judged when stable
Press the Function key.
The display changes to [Judgement
Condition].
Press the Zero/Tare key to select the
desired condition.
5 Setting the judgement range
 
全域判別
+５超を判別
 
Judge entire range Judge beyond +5
Press the Function key.
The display changes to [Judgement
Range].
Press the Zero/Tare key to select the
desired choice.
6 Setting the number of judgement points
 
１点設定
 
上下限設定
One point set Upper/lower limits set
Press the Function key.
The display changes to [Judgement
Points].
Press the Zero/Tare key to select the
desired choice.
7 Terminating the function setup

g
Press the Set key.
The balance terminates the function
setup and returns you to measurement
mode.
23