Victoria Arduino Adonis+

59
ENGLISH
Programmable hidden functions list
Self level: with pump- no pump (▲▼ UP/
DOWN to switch).
Self level sense:1-2-3(▲▼UP/DOWNto
switch)
Hot water: with pump - no pump
(▲▼UP/DOWNtoswitch).
Level in delivery: not active - active
(▲▼UP/DOWNtoswitch).
Temperature calibration: -15 - 0 - 15 °C/F
(▲▼UP/DOWNtoswitch).
Pressure calibration: -200 - 0 - 200 mbar
(▲▼UP/DOWNtoswitch).
Pre brewing: not active - active (▲ ▼ UP/
DOWN to switch).
Cup warmer: single - single temp. - double
temp(▲▼UP/DOWNtoswitch).
Clock calibration: -300 - 0 - 300 sec/month
(▲▼UP/DOWNtoswitch).
Serial connection: active - not active
(▲▼UP/DOWNptoswitch).
Least group:0-1-2-3(▲▼UP/DOWNto
switch).
Least serve:0-1-2-3(▲▼UP/DOWNto
switch).
DIRECT LINKS
In "machine ready" state you can go direct to
the settings below instead of surfing the menu.
SETTING THE TEMPERATURE POINT:
Press ENTER+▲togodirectlytotheSetting
Point menu (this will be bars or °C/°F depend
on the status view you were).
▲ ▼ press UP or DOWN to move up and
down the working Point.
Press ENTER to confirm and pass to the next
step.
MONITORING UNIT (°C/°F - BAR):
The display can also show you the pressure or
temperature status of the boiler; to pass from
onetotheother,pressthe▼keyonthedis-
play.
In the case of pressure, the reading will be shown
in bar, while for temperature, it will be in degrees
Celsius (°C) or Fahrenheit (°F). The display set-
ting for the temperature can be chosen from the
setpoint setting page. In fact, when choosing the
temperature mode, the setpoint will be shown in
degrees Celsius or Fahrenheit according to the
chosen measurement.
ON OFF STAND-BY
(ENERGY SAVING MODE)
This allows to rotate into the three working
modes/statuses.
Press RESET for 3 sec to switch on
 off 
stand-by the machine status.