60
ENGLISH
WARNING
RISK OF INTOXICATION
Once the filter-holder has been removed,
repeat delivery operations a few times to
eliminate any cleanser residues.
To carry out the washing procedure, proceed as
follows:
• Substitute the filter with the delivery unit
blind filter.
• Fill it with two spoonfuls of special cleanser
powder and insert it into the unit filter-holder.
• Press one of the coffee keys and halt it after
10 seconds.
• Repeat the procedure several times.
• Remove the filter-holder and carry our a few
deliveries.
6.5 CLEANING FILTERS
AND FILTER-
HOLDERS
Place two spoonfuls of special cleanser in half a
litre of hot water and immerse filter and fil-
ter-holder (without its handle) in it leaving them
to soak for at least half an hour. Then rinse
abundantly with running water.
6.
CLEANING AND
MAINTENANCE
6.1 SWITCHING OFF
THE MACHINE
6.2 CLEANING THE
OUTSIDE OF THE
MACHINE
To switch the machine off press the main switch
and set the machine to the "O" energy position.
The machine must be set to “O” power (switch
off and disconnector open) before any cleaning
operations are performed
Cleaning the work area: remove the worktop,
lifting it up from the front and sliding it out.
Remove the water collection dish underneath
and clean everything with hot water and cleans-
ers.
Cleaning the bottom: To clean all the chromi-
um-plated areas, use a soft, damp cloth.
WARNING
WARNING
Do not use solvents, chlorine-based prod-
ucts or abrasives.
It is not possible to clean the machine using
water jets or standing it in water.
6.3 CLEANING THE
STAINLESS
COFFEE-HOLDERS
6.4 CLEANING THE
UNIT WITH THE AID
OF THE BLIND
FILTER
The stainless coffee-holders are situated under
the delivery units, as shown in Fig. 21.
The machine is pre-set for cleaning the delivery
unit with a specific washing powder.
The machine will initiate washing cycle which
consists in the circulation of hot water followed
by regular breaks.
We recommend carrying out a washing cycle at
least once a day with special cleansers.
Fig. 21
NOTE: To clean proceed as follows:
• Turn the screw placed in the centre of the
coffee-holder.
• Slide the coffee-holder out and check that its
holes are not obstructed but clean.
• If obstructed, clean as described (Paragraph
“CLEANING FILTERS AND FILTER-
HOLDERS”).
We recommend cleaning the coffee-holder
once a week.
To Next Page
Loading...
