November 5, 2015 7/10
Setting the alarm
Press the Victorinox emblem for 4 seconds
until the display flashes. Release the Victori-
nox emblem again. You have now changed
over to the alarm setting mode.
By pressing the Victorinox emblem briefly
while the display is flashing, the alarm can be
switched on or off. When it is switched on
(On), the symbol appears in the display.
In the "On/OFF" setting mode, press the Vic-
torinox emblem again for 4 seconds until the
display flashes. Now release the Victorinox
emblem. You have changed over to the set-
ting mode submenu.
The arrow indicates the present setting direc-
tion. The change takes place automatically.
If the Victorinox emblem is pressed for longer
(at least 6 seconds), the adjustment speed is
increased (20 digits/s).
Brief pressure on the Victorinox emblem
causes the display to change by one digit in
the arrowed direction.
If the button is not pressed within 10 sec-
onds, the setting mode is quit automatically
and the new display is accepted.
Switching the alarm off
When the alarm sounds, it can be switched
off by applying brief pressure to the Victori-
nox emblem. The alarm acknowledgement
takes priority in all menus (even in the setting
menus). For example, if a button is pressed
in a setting mode and the alarm is actuated,
the button can be released, acknowledged
with a brief pressure and the action begun
previously repeated again.
Deactivating the alarm
Press the Victorinox emblem for 4 seconds
until the display flashes. Release the Victori-
nox emblem again. You have now changed
over to the alarm setting mode.
Brief pressure on the Victorinox emblem
causes the alarm to be switched off (OFF).
The symbol in the display goes out.
If the button is not pressed within 4 seconds,
the setting mode is quit automatically.
To Next Page
Loading...
Need help?
General