Videofied XMA - Arming - Away; Keypad and Badge Reader Arming; Remote Control Arming

3. Remote Control
 Press the button and instantly release.
 The remote control will beep twice in conrmation.
Note: A single low tone noties the command was not received at the
control panel. Move closer to the control panel and reattempt to arm the
system.
 The exit delay starts and short beeps are emitted from the Remote
Control and internal sirens (if installed)
1. Keypad (XMA/WMB)
Code Arming (XMA/WMB):
 Enter access code and press or to conrm.
 The keypad display will show
Quick Arm (XMA/WMB):
 Press and hold until the keypad rapdily beeps three times.
 The keypad display will show
Keypad Badge Reader (WMB):
 Present the badge to the symbol on the keypad and hold it for 2 seconds.
 The keypad beeps once and shows a green LED to conrm.
 The keypad display will show
Note: Detection from an instant device during arming will stop the arming
process and display . Press to restart the arming process or
to bypass the device. If no command is registered the system will automatically
restart arming after 3 minutes.
 For all keypad arming options the exit delay starts and short beeps are
emitted from the keypad and internal sirens (if installed). At the end
of the exit delay the display shows and the LED on the
keypad ashes RED ever two seconds.
Arming - Away
SYSTEM ARMING AWAY
ENGLISH
DETECTION
"DEVICE NAME"
SYSTEM ARMED
ARMING THE SYSTEM
ARMING THE SYSTEM
1