2. Badge Reader (BR)
Present the badge to the reader and hold for two (2) seconds.
The reader will beep twice in acknowledgement.
One red and one green LED will display on the reader and the exit
delay will start.
Note: Detection from an instant device or if there is a problem with arming the reader
will display two green LEDs for 5 seconds. Without action from the user the system will
attempt rearming in 3 minutes.
Short beeps are emitted from the reader and internal sirens
(if installed). At the end of the time delay the system is armed and the
red LED on the reader ashes every two seconds.
Arming - Away Continued...
Arming - Stay
1. Keypad (XMA/WMB)
Code Arming (XMA/WMB):
Enter access code and press
The keypad display will show
Quick Arm (XMA/WMB):
Press and hold until the keypad rapdily beeps three times.
The keypad display will show
Keypad Badge Reader (WMB):
Press the . Keypad will display
Present the badge to the symbol on the keypad and hold it for 2 seconds.
The keypad beeps once and shows a green LED to conrm.
The keypad display will show
Note: Detection from an instant device during arming will stop the arming
process and display . Press to restart the arming process or
to bypass the device. If no command is registered the system will automatically
restart arming after 3 minutes.
For all keypad arming options the exit delay starts and short beeps are
emitted from the keypad and internal sirens (if installed). At the end
of the exit delay the display shows and the LED on the
keypad ashes RED ever two seconds.
ARMING
SP1
SYSTEM ARMING
SP1
ARMING
SP1
ALARM SP1
BADGE OR CODE
DETECTION
"DEVICE NAME"
SYSTEM ARMED
ENGLISH
2 3
To Next Page
Loading...