ENGLISH
Partition Arming - Continued
3. Badge Reader (BR)
Note: Badges are congured during installation to use specc partitions. There is no option to choose
which partition to arm with the Badge Reader.
Present the badge to the reader and hold for two (2) seconds.
The reader will beep twice in acknowledgement.
One red and one green LED will display on the reader and the exit
delay will start.
Note: Detection from an instant device or if there is a problem with arming the
reader will display two green LEDs for 5 seconds. Without action from the user
the system will attempt rearming in 3 minutes.
Short beeps are emitted from the reader and internal sirens
(if installed). At the end of the time delay the system is armed and the
red LED on the reader ashes every two seconds.
Partition Disarming
1. Keypad (XMA/WMB)
No Event:
Partition Code Disarming (XMA/WMB)
Press until the desired partition to be disarmed is shown
Enter access code and press or to conrm.
The keypad display will show
Keypad Badge Reader Partition Disarming (WMB)
Press until the desired partition to be disarmed is shown
Present the badge to the symbol on the keypad and hold it for 2
seconds.
The keypad beeps once and shows a green LED to conrm.
The keypad display will show
Event Acknowledgment: During disarming you must acknowledge any events
that have happened since the system was last armed.
Perform any of the above disarming options
The keypad display will show
Press to acknowledge that the event has occured since last arming
The keypad display will show
Press , display will show
Mon 01/02 04:49
DISARMED LVL:1
Mon 01/02 04:49
DISARMED LVL:1
"Event"
"Event"
"Device Name"
Mon 01/02 04:49
DISARMED LVL:1
6 7
To Next Page
Loading...