Installation Instructions
29 of 38
IM-PP 724607 1218 ProPress
▶ Pull retaining pin out of press tool.
▶ Insert appropriate jaw.
▶ Push in retaining pin until it locks the jaw in place.
▶ Open the jaw and place at right angle on the tting.
▶ Look at insertion depth mark on the tube to make sure that the tube is
properly inserted into the tting.
▶ Hold trigger on press tool until press jaws have fully engaged the
tting. Jaws will automatically release after a full press is made.
▶ After pressing, open the jaws.
▶ Remove the press tool.
▷ Fitting is securely pressed.
WARNING!
Keep extremities and foreign objects away from press tool
during pressing operation to prevent injury or incomplete
press.
To Next Page
Loading...
