Viega ProPress - Page 32

Installation Instructions
32 of 38
IM-PP 724607 1218 ProPress
▶ Open XL-C ring and place at right angles on the 󶈵tting.
▶ Ensure that the XL-C ring is engaged on the 󶈵tting bead.
▶ With V2 ACTUATOR inserted into the press tool, open the V2
ACTUATOR.
▶ Connect the V2 ACTUATOR to the XL-C Ring.
▶ Look at insertion depth mark on the tube to make sure that the tube is
properly inserted into the 󶈵tting.
▶ Place the V2 Actuator onto the XL-C ring.
▶ Hold the trigger until the Actuator has engaged the XL-C ring.
WARNING!
Keep extremities and foreign objects away from XL-C Ring
and V2 ACTUATOR during pressing operation to prevent
injury or incomplete press.
▶ Release the V2 Actuator from XL-C ring.
▶ Remove the XL-C ring from 󶈵tting upon completion of the press.
▶ Remove product instruction label from 󶈵tting to indicate that press
has been completed.