Viega ProPress - Page 4

Table of Contents
4 of 38IM-PP 724607 1218 ProPress
List of Tables
Table 1 Fluids and water approved for use with ProPress systems ____ 7
Table 2 Gases approved for use with ProPress systems ____________ 7
Table 3 Minimum distance between press 󶈵ttings _________________ 20
Table 4 ProPress standard jaws clearance requirements ___________ 21
Table 5 ProPress standard jaws clearance requirements between
tube, wall, and 󶈶oor ___________________________________ 21
Table 6 ProPress compact jaws clearance requirements ___________ 21
Table 7 ProPress compact jaws clearance requirements between
tube, wall, and 󶈶oor ___________________________________ 21
Table 8 ProPress rings dimensions _____________________________ 22
Table 9 ProPress rings with V1 Actuator clearance requirements ____ 22
Table 10 ProPress rings with V2 Actuator clearance requirements ____ 22
Table 11 ProPress rings with V1 Actuator clearance requirements
between tube, wall, and 󶈶oor ___________________________ 22
Table 12 ProPress rings with V2 Actuator clearance requirements
between tube, wall, and 󶈶oor ___________________________ 23
Table 13 ProPress rings with C1 Actuator clearance requirements
between tube, wall, and 󶈶oor ___________________________ 23
Table 14 ProPress XL-C rings dimensions ________________________ 23
Table 15 ProPress XL-C rings clearance requirements ______________ 23
Table 16 ProPress XL-C rings clearance requirements between tube,
wall, and 󶈶oor ________________________________________ 23
Table 17 Minimum distance between existing soldered or brazed 󶈵tting
and ProPress 󶈵tting ___________________________________ 24
Table 18 Minimum distance between existing ProPress 󶈵tting and soldered
or brazed 󶈵tting _______________________________________ 25
Table 19 Minimum insertion depths for ProPress ___________________ 27
Table 20 Insertion depths for ProPress non-stop couplings __________ 28
Table 21 Insertion depths for ProPress extended non-stop couplings _ 28
Table 22 Minimum insertion depths ProPress XL-C _________________ 31
Table 23 Insertion depths for ProPress XL-C non-stop couplings _____ 31