Viessmann Fillstation medium - Operation; Preparing for Heating Water Softening;Heating Water Full Desalination; Digital Capacity Control; Starting Commissioning

17
Preparing for heating water softening/heating water full desali-
nation
Use the titration set to determine the
raw water hardness.
To do so, draw off raw water from any
draw-off point upstream of the heating
system.
Digital capacity control
Controls, display
OK
Digitale Kapazitäts-Kontrolle
OK
A
B
C
A
Display
B
Selection buttons
C
To confirm/save
Switching on:
■ The display is switched off when
delivered.
■ Press any button to switch on display.
■ C for capacity and the default resid-
ual quantity of 1166 l are shown.
If this display is shown, you are in the
main menu.
Starting commissioning
Press and hold OK for at least 3 s.
Setting the raw water hardness
Press the following buttons:
for the required value.
OK to confirm
Selecting the cartridge
Only if requested to do so, press the
following buttons:
to select the required water
treatment: HWE for heating
water softening, HVE for heat-
ing water full desalination
OK to confirm
to select the size of the car-
tridge in litres.
OK to confirm
GB
Operation
5593079