EasyManua.ls Logo

Viessmann NC-Box User Manual

Viessmann NC-Box
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Installation and service instructions
for contractors
VIESMANN
NC-Box
Pre-assembled unit for implementing the natural cooling function in conjunction
with brine/water heat pumps up to 17 kW
For applicability, see the last page
NC-Box
5675 869 GB 2/2015
Please keep safe.
Question and Answer IconNeed help?

Do you have a question about the Viessmann NC-Box and is the answer not in the manual?

Viessmann NC-Box Specifications

General IconGeneral
BrandViessmann
ModelNC-Box
CategoryHeating System
LanguageEnglish

Summary

Installation and Service Instructions

NC-Box Product Introduction

Pre-assembled unit for natural cooling function with brine/water heat pumps up to 17 kW.

Safety Instructions

Safety Symbols and Explanations

Explanation of warning symbols and notes for safe operation.

Target Group and Regulations

Identifies authorized personnel and lists regulations to be observed during installation.

Working on the System Safety

Safety precautions for electrical isolation and handling live components.

Information

Symbols and Product Details

Explanation of symbols and details on NC-Box design, function, and compatible heat pumps.

Preparing for Installation

Hydraulic Connection Methods

Describes on-site pipework and connection set methods for hydraulic hookup.

Siting and Transport Requirements

Transport Guidelines

Precautions against damage from impacts, compression, and tensile loads on appliance panels.

Installation Room Conditions

Ensuring a dry, frost-free room with ambient temperatures between 0 and 35°C.

Installation Sequence

Fitting the NC-Box

Instructions for physically mounting the NC-Box, with or without a connection set.

Opening and Hydraulic Connection

Opening the NC-Box

Procedure for opening the unit, including removing casing parts.

Hydraulic Connection Preparation

Steps for closing valves and draining heat transfer medium before connecting pipes.

Required Connections

Heating/Cooling Circuit Connections

Details required primary and secondary circuit connections for heating/cooling circuits.

Separate Cooling Circuit Connections

Details required primary circuit connection for separate cooling circuits.

Connection with Hydraulic Connection Set

Tightening Torques

Specified torques for fitting union nuts for hydraulic connections.

Installing the Contact Humidistat

Procedure for mounting and connecting the contact humidistat for condensate monitoring.

Electrical Connection

Electrical Safety Warnings

Warnings about injury from damaged wiring and incorrect connections.

Required Electrical Wiring

Details on heat pump connecting cable (NC signal) and KM BUS cable.

Power Supply

Electrical Isolation and Protection

Installation of isolators and RCDs for electrical safety.

Power Connection Procedure

Connecting NC-Box power to the heat pump control unit, fuse protection.

Commissioning and Adjustment

Commissioning Steps

Filling and venting circuits, and setting parameters for cooling operation.

Parts Lists

Overview of Assemblies

Lists major assemblies and components, including part ordering details.

Hydraulics

Electrical Equipment

Connection Set

Connection and Wiring Diagram

Circuit Diagram and Component Labels

Visual representation of electrical connections with labels for components and terminals.

Specification

Technical Specifications

Key dimensions, weight, ambient temperature limits, and hydraulic connection sizes.

Declaration of Conformity

Compliance and Directives

Lists standards and directives the NC-Box complies with, including CE marking.

Related product manuals