To Next PageTo Next Page
Need help?Do you have a question about the Viessmann Vitodens 100-W B1HF-M Series and is the answer not in the manual?
General| Type | Condensing Boiler |
|---|---|
| Installation | Wall-mounted |
| Heat Exchanger Material | Stainless Steel |
| Heating Output | 1.9 to 35 kW |
| Fuel Type | Natural Gas or Propane |
| Control System | Vitotronic control system |
| Water Pressure | Maximum 43.5 psi |
| Warranty | 5 years |
| Modulation Ratio | 1:10 |
Explains safety symbols and warnings for injury and material loss.
Covers safety measures for working on the system, including gas, electrical, and operational hazards.
Details the Vitodens 100-W, its components, and type plate information.
Covers necessary steps before installing the boiler, including connections and wall mounting.
Step-by-step guide on safely unboxing the boiler unit.
Instructions for physically mounting the boiler and making all necessary connections.
Guides on making proper gas and electrical connections for the appliance.
Guides through system setup via assistant or software tool for proper operation.
Explains how to access and set various operating parameters for system customization.
Covers accessing service menus, fault codes, and diagnostic procedures.
Details the operational modes, heating curves, and DHW functions of the appliance.
Illustrates the electrical interfaces and wiring for the HBMU heat management unit.
Lists key technical data, output ranges, pressures, and dimensions of the boiler.
Provides instructions for safely decommissioning and disposing of the appliance.
