Need help?Do you have a question about the Viessmann Vitodens 100-W B1HA and is the answer not in the manual?
General| Efficiency | Up to 95% AFUE |
|---|---|
| Fuel Type | Natural gas or propane |
| Heat Exchanger Material | Stainless steel |
| Type | Wall-mounted condensing boiler |
| Control | Vitotronic control system |
| Control System | Vitotronic |
| Warranty | 5 years |
| Modulation Ratio | Up to 1:6 |
Outlines the guideline nature of examples and copyright.
Details Viessmann's comprehensive heating solutions and support programs.
Explains the meaning of letters and numbers in Vitodens boiler model codes.
Breaks down the components of a typical Vitodens application code.
Compares boiler models against various heating applications like radiators and floor heating.
Explains symbols used in the application matrix and provides important notes.
Visual index of hydronic components like valves, pumps, and headers.
Visual index of electrical components like sensors, thermostats, and controls.
Lists specific applications with their codes and corresponding page numbers.
Illustrates the internal components of the Vitodens 100 boiler.
Lists the standard equipment provided with the boiler.
Details technical specifications for standard boilers, including gas input, output, and dimensions.
Provides specifications for flue gas temperature, mass flow, and condensate.
Details noise levels and how altitude affects boiler performance.
Technical data for the B1KA model's on-demand domestic hot water capabilities.
Provides detailed diagrams and measurements for the boiler's physical size.
Illustrates piping connection points and a legend for clarity.
Explains the boiler's integrated pump and selection criteria for system pumps.
Details the performance characteristics of the DHW heat exchanger.
Displays performance curves for the built-in Grundfos UPS15-78 pump.
Guidelines for boiler placement and flue gas system installation.
Recommendations for system layout, water connections, and corrosion protection.
Advice on underfloor heating systems and water quality treatment.
Details warranty coverage and exclusions.
Illustrates a low loss header system configuration and its pressure drop.
Details the pre-wired and field wiring connections for the application.
Step-by-step guide to set the boiler's water temperature.
Instructions for configuring the outdoor reset curve based on outdoor temperature.
Illustrates a system with radiant floor heating and its pressure drop.
Details wiring for an application with radiant floor heating.
Guide to configure DHW and heating temperatures for the application.
Illustrates a multi-zone system configuration and its pressure drop.
Details wiring for a multi-zone heating system.
Instructions for setting boiler temperature and outdoor reset.
Illustrates a system using zone valves and its pressure drop.
Details wiring for a system with zone valves.
Configure DHW and heating temperatures for the application.
Illustrates a microload setup and defines what a microload is.
Explains how to pipe for a microload to prevent short cycling.
Steps to put the boiler into emissions test or service mode.
Instructions to access and modify boiler parameters.
Settings for filling the system and reducing maximum heating output.
Settings for altitude, fuel type conversion, and parameter reset.
Configuration options for sensors, button tone, display, and comfort modes.
Settings for temperature units and DHW sensor type.
To Next Page