12
Configuring an additional remote control
1. Call up the subscriber number of the existing
remote control at the control unit of the heat gener-
ator:
In the "Service" menu, look under "Appliances
detected" to see which of the subscriber numbers
are already assigned to other remote controls (48,
49, 50 or 51).
2. In the following table, look for one of the unas-
signed subscriber numbers. Read off the relevant
subscriber number that needs to be set at the new
remote control (1, 2, 3 or 4).
Subscriber number
shown at the control
unit
Subscriber number to
be set at the remote
control
48 1
49 2
50 3
51 4
3. Follow the steps detailed in chapter "Reconfigura-
tion". Set the subscriber number specified in the
table.
Commissioning
Configuring the remote control (cont.)
5839309
Commissioning
To Next Page
