30
Restore the factory settings of your remote control,
for example if the remote control has already been
commissioned with a different heat generator.
All settings changed by you are restored to the deliv-
ered condition.
Note
Your contractor has to update the settings for the
remote control on the control unit of your heat genera-
tor too.
Press the following buttons:
1.
Operating button
C
: See Fig. 8, page 20.
2. to select "Factory reset".
3. to select "RUN".
4. Confirm prompt with .
The Vitotrol 300-E is restored to the factory set-
tings and then restarted.
5. Re-commission your remote control: See page 19.
Further settings
Restoring factory settings
5839615
Functions
To Next Page
Loading...
