9
2
Use the screws to secure the stand on the rear
side of the product as shown in the diagram.
Connecting the stand
- Only on some models.
1
Place a soft cloth on the table and put the
product with the screen facing downward.
Connect the stand as shown in the following
picture.
Using the Kensington
security system
The Kensington security system connector is
located at the back of the Monitor. For more
information of installation and using, refer to the
manual supplied with the Kensington security
system or visit
http://www.kensington.com
.
Connect the Kensington security system cable
between the Monitor and a table.
y
The Kensington security system is optional.
You can obtain additional accessories from
most electronics stores.
NOTE
To Next Page
Loading...
