7
4. Operation
4.1. Turning the poster on or off
1. Plug the power cord into an AC power outlet. Press Power Switch on the poster.
2. Now the poster is in standby mode. Wait a moment until the power indicator lights up, then press POWER
to turn on the
poster. (Be sure to wait for a few seconds before pressing POWER button. If you promptly press POWER button then the poster
may not respond or act wrongly.)
3. Press
button again to turn off the poster and put the poster in standby mode.
To cut off the power completely, press Power Switch on the poster.
Note: If the poster does not receive a postering signal for a certain time, the poster goes into standby mode.
4.2. The first time installation
Connect to power source and turn on the screen, the below installation menu page will display on the
screen.
Select desired menu language, then press START and turn to next page.
4.3. Operating the Float menu
1. Slide up from bottom of the screen center by two or more ngers to call in
HOME or INPUT SOURCE interface.
Note: Float Menu item need to be set to On in the Lock menu.
2. Press and drag
to any place of the screen.
3. Touch to control the MENU appear.
Call the annotation.
Back to previous.
Call the Home page.(Embedded Player)
Call the Volume bar.
Call the input source menu.
Call the application history
Call the Poster menu
To Next Page
Loading...
Need help?
General
