38
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure the cable connections are correctly made. For the
connection methods, see the Connection chapter.
Active VGA Out
Selecting On in the SYSTEM SETUP: Advanced > Standby Settings > Active VGA Out
outputs a VGA signal when the COMPUTER 1 and COMPUTER OUT sockets are
correctly connected to devices. The projector outputs the signal received only from
COMPUTER 1.
LAN Control
Making the following settings in the SYSTEM SETUP: Advanced > Standby Settings >
Network allows the projector to provide the network function when it is in standby mode.
See "Controlling the projector through a LAN environment" on page 31 for details.
• Enable Network Standby Mode: Allows the projector to provide the network
function in standby mode.
• Auto Disable Network Standby Mode: Allows the projector to disable the
network function after a set period of time after it enters standby mode. For
instance, if 20 min is selected, the projector is able to provide the network
function for 20 minutes after it enters standby mode. When 20 minutes is up, the
projector enters normal standby mode.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input/output jacks. See
"Connection" on page 12 for more details.
Muting the sound
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Audio Settings >
Mute menu.
2. Press / to select On.
If available, you can press on the remote control.
Adjusting the sound level
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Audio Settings >
Volume menu.
2. Press / to select a desired sound level.
If available, you can press / on the remote control to adjust the projector’s sound level.
Turning off the Power On/Off Ring Tone
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Audio Settings >
Power On/Off Ring Tone menu.
2. Press / to select Off.
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
To Next Page
Loading...
