50
Light source information
Extending light source life
The projection light source is a consumable item. To keep the light source life as long as
possible, you can do the following settings via the OSD menu.
Setting Light Source Settings
Setting the projector in Eco mode reduces system noise, power consumption and extends
the light source operation life.
To set the Light Source Settings, go to the SYSTEM SETUP: Advanced > Light Source
Settings menu and press / to select. Or you can press Eco Mode on the remote control
to select.
Setting Auto Power Off
This function allows the projector to turn off automatically after a set period of time once no
input source is detected to prevent unnecessary waste of light source life.
1. Open the OSD menu and go to the SYSTEM SETUP: Basic > Operation Settings
menu.
2. Press Enter and the Operation Settings page is displayed.
3. Highlight Auto Power Off and press / .
4. If the preset time lengths are not suitable for your need, select Disable. The projector
will not automatically shut down in a certain time period.
Setting Sleep Timer
This function allows the projector to turn off automatically after a set period of time to
prevent unnecessary waste of light source life.
1. Open the OSD menu and go to the SYSTEM SETUP: Basic > Operation Settings
menu.
2. Press Enter and the Operation Settings page is displayed.
3. Highlight Sleep Timer and press / .
4. If the preset time lengths are not suitable for your presentation, select Disable. The
projector will not automatically shut down in a certain time period.
Light
source
mode
Description
Normal Provides full light source brightness.
Eco
Reduces light source power consumption by 30% and lowers brightness
to extend the light source life and decreases the fan noise.
To Next Page
Loading...
