ViewSonic M1+ G2 - Online Firmware Update

60
Firmware Update Online
1. Go to: Home > Seng > Firmware Upgrade > Soware Update Online.
2. Select Enter by pressing OK on the remote control.
3. The system will check the ViewSonic website (OTA) and display the below dialog
message if their is new Firmware.
4. By selecng Yes, a progress bar will appear as the update process begins.
UPGRADING SOFTWARE
PLEASE DO NOT TURN OFF
52%
5. Upon reaching 100%, the projector will restart. The whole process will take about
10 minutes.
6. Aer updang the Firmware, it will take a few minutes to restart the projector.