ViewSonic M1+ G2 - USB Firmware Update

61
Firmware Update by USB
1. Download the latest version from the ViewSonic website and copy the le to a
USB device.
2. Plug the USB into the projector, then go to: Home > Seng > Firmware Upgrade
> Soware Update By USB.
3. Select Enter by pressing OK on the remote control.
4. The system will detect the Firmware version and display the above dialog
message.
5. By selecng Yes, a progress bar will appear as the update process begins.
6. Aer reaching 100%, the projector will restart. The whole process will take about
10 minutes.
7. Aer updang the Firmware, it will take a few minutes to restart the projector.
NOTE: Only the USB A port can support Firmware updang (USB format: FAT32).