ViewSonic N1900w User Manual

ViewSonic N1900w
12
ENGLISH
Installation
1. Insert Remote Control Batteries
2. Connecting RF antenna or Cable TV Wire
Make sure the power is OFF before installing your Multimedia TV Display. Connect
the Multimedia TV Display to TV antenna wire or cable/satellite box with 75-ohm
coaxial cable. Preset the TV channels into memory with AUTO SCAN function when
using an antenna or cable TV system without a cable connecter box. See page 17.
RF Cable or Adapter
1 Remove the battery cover by pulling then lifting the knob on the cover.
2 Insert the batteries, corresponding to the (+) and (-) markings on the battery compartment.
3 Reattach the battery cover.
CAUTION
• Only use the specified AA batteries.
• Do not mix new and old batteries. This may result in cracking or leakage,
which may pose a risk of fire or lead to personal injury.
• Insert batteries according to (+) and (-) markings. Inserting the batteries
incorrectly may result in cracking or leakage, which may pose a risk of fire or
lead to personal injury.
• Dispose of the battery in accordance with local laws and regulations.
• Keep the battery away from children and pets.
• When the remote control will not to be used for an extended period, remove
the batteries.

ViewSonic N1900w Specifications

General

Brand	ViewSonic
Model	N1900w
Category	Monitor
Language	English