30
the last 30 seconds of counting down/up, and a triple beep sound will be produced
when the timer is up.
8. To activate the presentation timer, press and press / to highlight Start
Counting and press Enter.
9. A confirmation message displays. Highlight Yes and press Enter to confirm. You will
see the message “Timer is On” displaying on the screen. The timer starts counting
when the timer is on.
To cancel the timer, perform the following steps:
1. Press on the remote control or go to the BASIC > Presentation Timer menu.
2. Highlight Off. Press Enter. A confirmation message displays.
3. Highlight Yes and press Enter to confirm. You will see the message “Timer is Off”
displaying on the screen.
Hiding the image
In order to draw the audience's full attention to the presenter, you can press Blank on the
projector or remote control to hide the screen image. Press any key on the projector or
remote control to restore the image. The word 'BLANK' appears at the lower right corner of
the screen while the image is hidden.
You can set the blank time in the BASIC > Blank Timer menu to let the projector return
the image automatically after a period of time when there is no action taken on the blank
screen.
Once Blank is pressed, the projector enters SuperEco mode automatically.
CAUTION
Do not block the projection lens from projecting as this could cause the blocking object to
become heated and deformed or even cause a fire.
Creating your own startup screen
In addition to selecting the projector preset startup screen from among Black, Blue, or
ViewSonic screen, you can make your own startup screen that is a picture projected from
your computer or video source.
To create your own startup screen:
1. Project the picture you want to use as your startup screen from either a computer or
video source.
2. Open the OSD menu and go to the BASIC > Screen Capture menu.
3. Press Enter.
4. A confirmation message displays. Press Enter again.
5. The message 'Screen Capturing...' displays while the projector is processing the
picture. Please wait.
6. If the action is successful, you see the message 'Captured Succeeded' on the screen.
The captured picture is saved as Screen Capture and have been set as your current
startup screen.
In the unlikely event that the capturing action fails, change your target picture. When it
happens, please set the resolution of the input signal under native resolution and try again.
To Next Page
Loading...
