ViewSonic PJ502 14
Operating the remote control
The remote control works with the projector's remote sensor.
• The range of the remote sensor is 3 meters with a 60- degree range (30 degrees to the left
and right of the remote sensor).
• Also a remote signal reflected in the screen etc. may be available. If it is difficult to send a
remote signal to the sensor directly, please try.
• Since the remote control uses infrared light to send signals to the projector (Class1 LED),
be sure to use the remote control in an area free from obstacles that could block the re-
mote control's output signal to the projector.
CAUTION
X Be careful in handling the remote control.
* Do not drop or otherwise expose the remote control to physical impact.
* Do not get the remote control wet or place it on wet objects. Doing so may result in mal-
function.
* Remove the batteries from the remote control and store them in a safe place if you won't
be using the remote control for an extended period.
* Replace the batteries whenever the remote control starts to malfunction.
* When strong lights, such as direct sunlight or light from an extremely close range (such
as from an inverter fluorescent lamp), hit the projector's remote sensor, the remote con-
trol may cease to function. Adjust the direction of the projector to keep light from directly
hitting the projector's remote sensor.
about 3 meter
To Next Page
Loading...
Need help?
General
