ViewSonic PJ502 - SETUP Menu

ViewSonic PJ502 26
SETUP menu
With the SETUP menu, items shown in the table below can be perormed.
Select an item using the menu cursor buttons S/T, and press the menu
cursor button X or the ENTER button on the remote control to progress.
Then perform it referring to the following table.
Item Description
KEYSTONE Using the buttons S/T corrects the keystone distortion.
Upper in the data
Q Lower in the data
* The adjustable range of this function will vary with the type of input signal. At
some signals, this function may not work well.
* When the V:INVERT or the H&V:INVERT is selected under the item MIRROR, if
the projector screen is inclined or if the projector is angled downward, this function
may not work correctly.
* When the zoom adjustment is set to the TELE side, this correction may be
excessive. This function should be used with zoom set to WIDE whenever possi-
ble.
WHISPER Using the buttons S/T turns off/on the whisper mode.
NORMAL
 WHISPER
* When the WHISPER is selected, acoustic noise and screen brightness are
reduced.
MIRROR Using the buttons S/T switches the mode for mirror status.
NORMAL
 H:INVERT  V:INVERT  H&V:INVERT
 
VOLUME Using the buttons S/T adjusts the volume.
High
Q Low